Skip to content
Speaker Tester

Stereo · Channel check

Left Right Speaker Test

Play sound in one channel at a time and see which side should be playing. If what you hear doesn’t match what lights up, your speakers or cables are swapped.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Pick a channel, then press play.

Channel
Signal
20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

What to do if left and right are swapped

On speakers, swap the cables at the amplifier or at the speakers themselves (red is right by convention). On headphones, check you’re wearing them the right way round: look for the L and R markings. If the problem only happens on one device, check its sound settings for a “swap channels” or mono option.

If one side is silent, try the other cable or input first. A dead channel that follows the cable is a cable fault, and one that stays on the same speaker is a speaker or amplifier fault.

Frequently asked questions

How do I test my left and right speakers?

Press Play and select Left. You should hear sound only from the left speaker. Then select Right and check the sound moves to the right speaker. Center should sound like it comes from directly between them.

How do I know if my left and right speakers are swapped?

Play the Left channel: if the sound comes from your right-hand speaker, the channels are swapped. Sit facing the speakers, close your eyes and point to where the sound comes from before you look at the screen. To fix it, swap the two speaker cables at the amplifier or the plugs at the source. With headphones, check the L and R markings and make sure you’re wearing them the right way round. Then run the test again to confirm.

Why is sound only coming from one speaker?

Usually the balance setting is off-center, a cable or plug is loose, or one channel has failed. First check the balance slider in your sound settings and make sure mono audio is turned off. Then swap the left and right cables: if the silence moves with the cable, replace the cable; if it stays with the same speaker, the speaker or that amplifier channel is faulty. Play Left and Right above after each change to see what fixed it.

Why does the center channel sound like it comes from the middle?

Center plays the same signal from both speakers at equal level. Your brain fuses them into a “phantom” image between the speakers. If center seems pulled to one side, one speaker is louder, closer, or you’re not sitting in the middle.

Why do I hear the left channel in both ears?

Your device is probably set to mono audio (an accessibility setting on iOS, Android, Windows and macOS), or you’re using a mono Bluetooth headset profile. Turn off mono audio and make sure your headphones are connected for media, not calls.

Is noise or tone better for a channel test?

Noise is easier to locate because it contains many frequencies, so it’s the default. A pure tone can be useful when the room is noisy or you want to compare loudness between sides.

Does this test work on phone speakers?

Yes, if your phone has stereo speakers. Many phones put one speaker at the bottom and use the earpiece as the second, so hold the phone sideways. Phones with a single speaker will play both channels from the same place.

How do I test speaker wire?

Check the connections and wire ends by eye, then confirm the wiring by ear with a left/right and phase test. Switch the system off, make sure every terminal is tight, and look at the bare ends for loose strands, corrosion or strands touching the other terminal. Check the striped or marked conductor goes to + at both ends. Reconnect, play Left and Right here to check each channel reaches the correct speaker, then run the phase test to confirm polarity.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.