Skip to content
Speaker Tester

Bass · Crossover

80 Hz Test Tone

80 Hz is the THX-recommended crossover point for home theater: below it the subwoofer takes over, above it your speakers do. That makes it the best single tone for checking how well they blend.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Test tone

80Hz

D♯2 +49 cents · Sine wave

Waveform
Output

Sine is the pure test tone. Square, triangle and sawtooth add harmonics above 80 Hz, which makes rattles and distortion easier to hear.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

Why 80 Hz is the standard crossover

Below roughly 80 Hz, our ears can barely tell where bass is coming from, because the wavelengths are several metres long. That means a single subwoofer can sit anywhere in the room without pulling the sound towards it, as long as the crossover stays around 80 Hz. Push the crossover much higher and you start to hear the sub as a separate source.

For most speakers, setting the AV receiver’s crossover to 80 Hz gives the best balance: the main speakers no longer have to work hard on deep bass, and the sub plays where it is strongest. The open low E on a guitar, E2 at 82.4 Hz, sits right on top of this crossover.

Checking the blend between sub and speakers

At the crossover frequency, both the subwoofer and the speakers are playing at the same time, so they need to be in step. If they are out of phase, they partly cancel and 80 Hz sounds weak or hollow. Play this tone from your listening seat and flip the subwoofer’s phase switch, or turn its phase dial: keep the setting where the tone is loudest.

Then compare with the 60 Hz and 100 Hz tones. If 80 Hz is noticeably quieter than both, there is still a gap at the crossover; try moving the sub closer to the front speakers. If it is much louder, reduce the subwoofer level a little.

Frequently asked questions

What crossover should I use for my subwoofer?

80 Hz is the best starting point for most systems. Use 60 Hz for large floor-standing speakers and 100–120 Hz for very small satellites or soundbars.

Why does 80 Hz sound weak with my subwoofer?

The sub and speakers are probably partly cancelling at the crossover. Flip the sub’s phase switch or move it closer to the front speakers and listen again.

Can I hear where an 80 Hz tone comes from?

Only roughly. Below about 80 Hz, sound direction becomes hard to judge, which is why one subwoofer can be placed almost anywhere.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.