Skip to content
Speaker Tester

Bass · Mains hum

60 Hz Test Tone

60 Hz is the US and Canadian power-line frequency and the source of the familiar low hum in audio gear. It is also right in the thump of a kick drum, which makes it one of the most useful subwoofer test tones.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Test tone

60Hz

B1 −49 cents · Sine wave

Waveform
Output

Sine is the pure test tone. Square, triangle and sawtooth add harmonics above 60 Hz, which makes rattles and distortion easier to hear.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

Mains hum at 60 Hz

North America, Central America, parts of South America including Brazil, South Korea, Taiwan, the Philippines, Saudi Arabia and western Japan use 60 Hz power. Hum from ground loops shows up at exactly this pitch, while transformers and fluorescent lighting tend to buzz at twice the frequency, 120 Hz, because their magnetic cores flex twice per cycle.

If your system hums with the music paused, play this tone at a low level and compare. A match points to a ground loop, an unshielded cable running alongside a power cord, or a faulty power supply. Plug everything into one power strip, separate audio and power cables, and try a ground-loop isolator.

Using 60 Hz to set up a subwoofer

Most of the punch in kick drums and bass lines is between 50 and 100 Hz, and 60 Hz is near the middle of a typical subwoofer’s best range. It is also close to common crossover points, so you will often hear both the sub and the main speakers playing it.

Switch the output between Left, Both and Right: with a subwoofer, the tone should stay at a similar level, because the sub plays bass from both channels. If 60 Hz is noticeably louder or softer than nearby tones, try the subwoofer’s phase switch (0° or 180°) and keep the setting that sounds loudest at your seat.

Frequently asked questions

Why do I hear a 60 Hz hum from my speakers?

Most often a ground loop between devices on different outlets, or interference picked up by unbalanced cables. Plugging everything into the same outlet usually fixes it.

Is 60 Hz bass or sub-bass?

It sits at the boundary: most engineers call 20–60 Hz sub-bass and 60–250 Hz bass. It is the frequency of a kick drum’s thump.

Should my subwoofer crossover be at 60 Hz?

Only if your main speakers are large and reach well below 60 Hz. For most systems 80 Hz is the better starting point.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.