Skip to content
Speaker Tester

Midrange · Body

400 Hz Test Tone

400 Hz sits in the honky, boxy part of the midrange and is also the frequency of electrical power on aircraft and many military systems. Use it to check midrange clarity and recognise that whine.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Test tone

400Hz

G4 +35 cents · Sine wave

Waveform
Output

Sine is the pure test tone. Square, triangle and sawtooth add harmonics above 400 Hz, which makes rattles and distortion easier to hear.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

400 Hz on aircraft and ships

Aircraft and many military and marine systems use 400 Hz AC power instead of 50 or 60 Hz, because transformers and motors can be much smaller and lighter at the higher frequency. That is the source of the faint whine some people hear in aircraft intercoms, in-flight entertainment and headsets plugged into seat armrests.

If you hear a steady whine in a headset on a plane, play this tone to compare. It is not a fault in your headphones; it is the aircraft’s power system leaking into the audio.

Boxy and honky midrange

Between roughly 300 and 600 Hz, too much energy makes sound boxy or honky, like talking into a cardboard tube. Small speakers often have a bump here to sound louder, and some headphones peak here too. The note G4 (392 Hz) is just below this tone.

Play 400 Hz alongside 250 Hz and 1 kHz at the same volume. On a well-balanced speaker they will sound fairly even. If 400 Hz jumps out, an EQ cut of a few decibels around 400 Hz often makes voices and guitars clearer. Square and sawtooth waves add harmonics that make midrange resonances even easier to hear.

Frequently asked questions

Why do airplanes use 400 Hz power?

Transformers and motors for 400 Hz can be much smaller and lighter than for 50 or 60 Hz, which matters on an aircraft.

Why do my speakers sound honky?

A peak in the 300–600 Hz range. Compare this tone with 250 Hz and 1 kHz; if it is louder, reduce it slightly with EQ.

Is 400 Hz a good test tone?

Yes. It is easy for any speaker to play, so it is useful for comparing channels and finding midrange resonances.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.