Skip to content
Speaker Tester

Midrange · Telephone band

300 Hz Test Tone

Traditional phone lines carried only 300 to 3,400 Hz, yet you can still recognise voices. 300 Hz is also roughly where phone speakers start producing useful sound, which makes it a good phone speaker check.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Test tone

300Hz

D4 +37 cents · Sine wave

Waveform
Output

Sine is the pure test tone. Square, triangle and sawtooth add harmonics above 300 Hz, which makes rattles and distortion easier to hear.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

Why voices survive the 300 Hz cut-off

Classic narrowband telephony passes only 300–3400 Hz, which removes the fundamental pitch of most male voices and some female voices. You still hear the right pitch because of the “missing fundamental” effect: your brain works out the fundamental from the spacing of the harmonics that remain.

Phone calls on modern networks (HD Voice, VoLTE) and Bluetooth wideband speech extend the band to about 50–7000 Hz, which is why they sound fuller. If your Bluetooth headphones suddenly sound thin and phone-like, they have switched to call mode.

Testing a phone speaker at 300 Hz

Most phone loudspeakers produce little below 200–400 Hz. Play this tone on your phone at about two-thirds volume: it should be clearly audible and clean. A rattle or buzz here, especially after a drop, suggests a damaged speaker membrane or a loose part.

If the tone sounds unusually quiet or muffled, check that the grille isn’t blocked by lint, dust, a case or water. The speaker cleaner on this site plays a 165 Hz tone designed to push water out of the grille.

Frequently asked questions

Why do phone calls cut off at 300 Hz?

Old telephone networks were designed for 300–3400 Hz to save bandwidth while keeping speech understandable. HD Voice calls use a much wider band.

Should my phone speaker play 300 Hz?

Yes, most phones play it clearly. Lower tones often fade away on phones because their speakers are tiny.

What note is 300 Hz?

It lies between D4 (293.7 Hz) and D♯4 (311.1 Hz), a little sharp of D4.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.