Skip to content
Speaker Tester

Bass · LFE channel

120 Hz Test Tone

120 Hz marks the top of the low-frequency effects (LFE) channel in Dolby and DTS soundtracks, and it is the buzz you hear from transformers and lighting in 60 Hz countries.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Test tone

120Hz

B2 −49 cents · Sine wave

Waveform
Output

Sine is the pure test tone. Square, triangle and sawtooth add harmonics above 120 Hz, which makes rattles and distortion easier to hear.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

The top of the LFE channel

In 5.1 and 7.1 soundtracks, the “.1” LFE channel carries effects up to 120 Hz. Your AV receiver combines that channel with any bass it redirects from the main speakers, then sends it to the subwoofer. To avoid filtering twice, set the subwoofer’s own low-pass control to its maximum or “LFE” position and let the receiver manage the crossover.

If 120 Hz sounds like it comes from the subwoofer’s corner of the room, the sub’s low-pass filter is set too high or the receiver isn’t managing bass. You will hear voices and drums seem to pull towards the sub.

120 Hz transformer and lighting buzz

In North America and other 60 Hz countries, transformers, dimmers and fluorescent lighting buzz at 120 Hz, twice the mains frequency, because their magnetic cores and materials flex on each half of the cycle. This is different from ground-loop hum at 60 Hz: it is often a physical buzz from the device itself, and it doesn’t go away when you disconnect the audio cables.

Play this tone quietly and compare: if it matches the buzz you hear from an amplifier or a lamp, the source is mechanical. Moving audio cables away from dimmers and power bricks helps with interference, but a loud transformer buzz inside an amplifier is a hardware issue.

Frequently asked questions

What should my subwoofer low-pass be set to?

When an AV receiver handles bass management, set the subwoofer’s own low-pass to maximum or LFE and set the crossover in the receiver, usually at 80 Hz.

Why does 120 Hz hum come from my amplifier?

Transformer cores vibrate at twice the mains frequency. In 60 Hz countries that is 120 Hz. Loud buzz usually needs a repair or a different power supply.

Is 120 Hz bass?

Yes, it is upper bass: the warmth of bass guitars and male voices. It is above most subwoofer crossovers, so main speakers should play it.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.