Skip to content
Speaker Tester

Treble · Sensitivity

4 kHz Test Tone (4000 Hz)

4 kHz is close to the frequency your ears are most sensitive to, and it is where noise-induced hearing loss usually shows up first. Keep the volume low: this tone sounds louder than lower ones.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Test tone

4kHz

B7 +21 cents · Sine wave

Waveform
Output

Sine is the pure test tone. Square, triangle and sawtooth add harmonics above 4 kHz, which makes rattles and distortion easier to hear.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

The ear’s most sensitive range

Human hearing is most sensitive between about 2 and 5 kHz, with a peak around 3–4 kHz, thanks to the resonance of the ear canal. That is why smoke alarms, which typically beep around 3 kHz, and babies’ cries are so hard to ignore. A 4 kHz tone at the same setting as a 100 Hz tone will sound far louder, so always start low.

Because of that sensitivity, a harsh speaker or headphone peak in this region makes listening tiring quickly. If music sounds shouty or fatiguing, compare this tone with 1 kHz at the same setting.

The 4 kHz “noise notch”

Long exposure to loud noise damages the hair cells of the inner ear, and the first loss usually appears as a dip around 4 kHz (often between 3 and 6 kHz) on an audiogram, known as the noise notch. Musicians, factory workers and people who listen to headphones loudly are most at risk.

This page can’t diagnose hearing, but if 4 kHz sounds clearly fainter in one ear than the other with headphones you trust, or if you notice ringing after loud events, consider a hearing test and use hearing protection at concerts.

Frequently asked questions

Why does the 4 kHz tone sound so loud?

Our ears are most sensitive around 3–4 kHz, so the same signal level sounds much louder than lower tones. Keep the volume low.

What is the 4 kHz notch?

A dip in hearing around 4 kHz typical of noise-induced hearing loss. Only a proper audiogram can show it.

Can I check my tweeters with 4 kHz?

Yes. At 4 kHz most two-way speakers play mainly from the tweeter, so a silent tweeter will make this tone sound dull or very quiet.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.