Skip to content
Speaker Tester

Stereo · Polarity check

Speaker Phase Test

Hear the difference between both speakers pushing together and pulling against each other. If “out of phase” sounds better than “in phase”, a wire is reversed.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

In phase · + / +

Should sound focused, centered and full, with solid bass.

Out of phase · + / −

Should sound diffuse, wide and thin, hard to pin down.

Polarity
Signal

Result: if “Out of Phase” sounds fuller and more centered than “In Phase”, one speaker’s + and − wires are swapped. Flip them on one speaker only.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

Why polarity matters

When one speaker is wired backwards, its cone moves out while the other moves in. Bass waves cancel each other, the stereo image loses its center, and vocals sound vague. It’s one of the most common setup mistakes, and one of the easiest to fix: check that red (+) goes to red and black (−) to black at both the amplifier and the speaker.

Frequently asked questions

How do I check if my speakers are out of phase?

Compare the In Phase and Out of Phase signals: if the out-of-phase one sounds fuller and more centered, your speakers are wired out of phase. Sit in the middle between the speakers and keep the volume moderate. In phase should sound solid, focused and rich in bass; out of phase should sound wide, hollow and thin. If it’s the other way round, swap the + and − wires on one speaker only, then run the test again to confirm.

What’s the difference between phase and polarity?

Polarity is whether a signal is inverted (+ or −). Phase is a timing relationship that varies with frequency. Wiring mistakes cause a polarity inversion, but the test is commonly called a phase test, and both terms are used here.

Why does out-of-phase sound weird in headphones?

With headphones, an inverted channel produces an unnatural, “inside-out” sensation that’s hard to locate. That’s normal and shows the test is working. Your headphones are wired correctly if the In Phase step sounds normal.

Why is the out-of-phase signal silent on my speaker?

Your device or speaker is mono, so it adds left and right together. An inverted signal plus the original cancels to silence. That’s a reliable sign the output is mono, not stereo.

How do I test speaker wire polarity?

Check that each wire runs + to + and − to −, then confirm it by ear with the phase test. Speaker cable marks one conductor with a stripe, ridge, printed text or a different color; follow that conductor from the amplifier’s + terminal to the speaker’s red + terminal on both channels. Then play the In Phase signal above. Solid, centered sound with full bass means the polarity is right, while a hollow, vague image means one speaker is reversed.

How do I test a speaker with a battery?

Briefly touch a single 1.5 V AA battery to the terminals of a disconnected woofer and watch which way the cone moves. If it pushes outward, the battery’s + is on the speaker’s red + terminal; if it pulls inward, the polarity is the other way round. Only touch it for a moment. Never use a 9 V battery, never try it on a tweeter, and always disconnect the speaker from the amplifier first. For a connected system, use the in-phase test above instead.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.