Skip to content
Speaker Tester

Sub-bass · Infrasound edge

20 Hz Test Tone

20 Hz is where hearing gives way to feeling. Play it to find out whether your subwoofer truly reaches the bottom of the audible range, or whether it only huffs air and rattles the room.

  • Free
  • No download
  • No sign-up
  • Audio stays on your device

Loading…

Test tone

20Hz

D♯0 +49 cents · Sine wave

Waveform
Output

Sine is the pure test tone. Square, triangle and sawtooth add harmonics above 20 Hz, which makes rattles and distortion easier to hear.

20%

Start quiet. Lower your device volume before you press play, then raise it slowly. Test tones are pure and can be louder than music at the same setting.

Can you actually hear 20 Hz?

Barely. Your ears are vastly less sensitive at 20 Hz than in the midrange: the threshold of hearing is close to 80 dB SPL here, compared with almost 0 dB at 3–4 kHz. At normal listening levels many people hear nothing at all, and what they notice is a fluttering pressure in the ears, the chest or the floor. Below 20 Hz is infrasound, which is felt rather than heard.

That makes 20 Hz a revealing test. If you hear a clear, hummy note, you are almost certainly hearing harmonics at 40, 60 and 80 Hz created by the speaker struggling, not the tone itself. A clean subwoofer at 20 Hz sounds like very little and feels like a lot.

What 20 Hz tells you about a subwoofer

Few subwoofers are flat to 20 Hz. Sealed subs roll off gently, so they still produce some output here. Ported subs fall off sharply below their port tuning, typically somewhere between 18 and 30 Hz; below that the cone is no longer controlled and can flap, click or make the port chuff. If you hear any of those, turn down immediately and consider enabling the sub’s subsonic or rumble filter.

Rooms change the result. In small rooms and cars, “room gain” boosts the lowest frequencies, so a sub that measures weakly at 20 Hz on paper can feel powerful in a car. The pipe organ is one of the few instruments that goes this low: a 32-foot stop’s bottom C sits at about 16 Hz.

Frequently asked questions

Is a 20 Hz tone safe for my speakers?

At moderate volume, yes. Small speakers can’t reproduce 20 Hz and may move their cones a long way trying, so keep the volume low on laptops, phones and bookshelf speakers.

Why can’t I hear the 20 Hz tone?

Most speakers can’t play it, and human hearing is very insensitive this low. Try headphones with a good seal or a capable subwoofer, and expect to feel pressure rather than hear a note.

Why do I hear a higher note instead of 20 Hz?

That is harmonic distortion: the speaker is producing 40, 60 or 80 Hz because it can’t cleanly move enough air at 20 Hz. Lower the volume and it should fade.

Keep testing

See All Tests

Want to check everything in one go? Run the full speaker test on the homepage.